​Milking 3X - The Advanced Level of Dairymaster's Award-Winning Goat Rotary Milking Parlor

​Milking 3X - The Advanced Level of Dairymaster's Award-Winning Goat Rotary Milking Parlor


A good milking routine involves several factors, both human and animal. A good milker is attentive to details, follows routine practices, and closely monitors the animals for any signs of mastitis. They also wear disposable gloves to prevent the spread of disease. They must know the importance of each step in milking and avoid shortcuts that endanger the animal's health. Children milkers must learn the signs of mastitis and the proper way to perform the task.

The duration of milking is approximately four hours in the morning, two hours in the afternoon, and one hour in the evening. In addition, the cows must be fetched for milking and parlor maintenance takes an additional 30 minutes. The process also involves writing reports and checking information. Milking 3X is an advanced level and requires at least six months of dedication and a monitoring program. The following sections explain the details of the advanced milking program.

The milking process involves two different methods. These methods are known as "stripping" and "full hand" respectively. In the former method, the teat is held between the forefinger and thumb, while in the latter, the entire hand is used to squeeze the teat with the palm of the hand. The milk is then extracted from the cow's teat by air pressure or vacuum. The milk is then filtered before being poured into a bulk tank.

Efficiency in milking is measured by the number of parlor turns performed per hour. The time taken for each step, including udder prep, the first unit attachment, and the cow's exit, should be noted. The speed of milking should be between 10 and 15 minutes. The time spent unloading the parlor depends on the parlor configuration, the holding area, and the return alleys. For milking to be effective, a parlor should be highly efficient.

The milking process begins with the feeding of highly palatable feedstuffs. Upon entering the milking unit, the cow is contacted by a cow identification sensor. Then, an automatic gate system sends the cow out of the unit. At this point, automatic teat cleaning and milking are performed. The milking process is complete with the help of concentrated feedstuffs. These milking methods provide the milk that farmers need.

The introduction of AMS units into the market has drastically reduced the number of dairy farmers implementing a traditional method of milking. The new automated milking methods improve the quality of life of the farmers. Their cows do not have to be milked before or after work. Milking with AMS saves farmers time and allows them to go to work later in the morning. Moreover, the farmers reported better quality milking, more time for hobbies, and smaller herds.

The milk price model generated two tables, one for each variable. One table is based on the daily milk price in $0.50 increments. The other table gives the gains/losses for a particular daily marginal revenue per 100 milking cows. The same information is shown on an annual basis. This study reveals the impact of milk price on dairy farmers' profits. It has been shown that milk price increases in the market can significantly increase the milking efficiency of dairy cows.